3.3
Reader assembly and installation
Personnel:
Electrical expert
Requirements:
There is a pre-installed DIN 49703 switch box in the wall at the required installation location.
The connecting cable between the controller and the switch box has already been routed and connected to
the controller.
1.> Disconnect power supply of controller.
Fig. 14: Reader frame
2.> Screw frame of reader to pre-installed switch box. Make sure that the support rails for the reader are on
the right and left.
Fig. 15: Cover at rear of reader
3.
Unscrew cover from rear of reader (Fig. Fehler! Verweisquelle konnte nicht gefunden werden./1).
Assembly and installation
27