Russell Hobbs 21150-70 Instructions Manual page 67

diagrams
1 hook
2 filter
C KEEP WARM – 40 MINUTES
16 If you have chosen a temperature below 100, and you want to keep the water warm:
17 Press and release the > button.
18 > will blink on the display.
19 Use the u and d buttons to set the temperature.
20 This function only works at the 95, 90, 85, 80, 75, 70, 65, 60, 55, 50, 45, 40, 35, 30, and 25
settings.
21 After 5 seconds, > will stop blinking, to show the temperature is set.
22 The element will switch on intermittently, to keep the water hot.
23 After 40 minutes, the function will switch off.
24 > will disappear from the display.
25 The display will show the temperature of the water in the kettle.
C SWITCHING OFF
26 When the water boils the element will switch off.
27 To stop the kettle, press and release the < and/or > buttons to remove the corresponding
< and/or > icons from the display.
28 The display will show the temperature of the water in the kettle.
29 To save electricity, unplug the stand.
30 The appliance will remember the setting for up to 24 hours.
C GENERAL
31 When you lift the kettle, you may see moisture on the stand. Don't worry – it's the steam
used to switch off automatically, which then condenses and escapes via vents under the
kettle.
32 You may see some discolouration on the floor of the kettle. Again, don't worry – it's due to
the bonding of the element to the kettle floor.
33 If you normally heat water to less than 100°C, and keep it warm, you may ignore the <
button, and use the keep warm function on its own.
F USING WITH INSUFFICIENT WATER
34 This will shorten the life of the element. A boil-dry cut-out will switch the kettle off.
35 You must then remove the kettle from its stand to reset the cut-out.
36 Sit the kettle on the work surface till it's cold.
C CARE AND MAINTENANCE
37 Unplug the stand from the wall socket, and let the kettle cool down fully before cleaning.
38 Wipe all surfaces with a clean damp cloth.
39 Keep the connectors dry.
C CLEANING THE FILTER
40 Switch the kettle off, and let it cool.
41 Open the lid.
42 Grip the top of the filter, and push it down and into the kettle to release it.
43 Lift or tip it out of the kettle.
44 Rinse the filter under a running tap while brushing with a soft brush.
C REPLACE THE FILTER
45 Fit the bottom of the filter into the mount at the bottom of the spout.
46 Push the top of the filter towards the spout, to force the top hooks under the rim of the kettle.
3 mount
4 lid
5 lid lock
67
6 handle
7 stand