Advertisement
Renegade Cluster - Installation
FIGURE 3: Connection Guide
See Figure #2 for more wiring information and numbering.
Power Draw = 0.2 Amp
3A to 5A Inline Fuse Recommended
for +12
GPS Hot Start (#8 Red/Black Wire)
Connect to +12VDC non-
(25 micro-amp draw) See Figure 8
Attach to included wire harness and connect to Fuel Level Sender (See Figure 5)
Power distribution cable
+12 Volts
(Main gauge power)
+12 Volts Dash lighting
(Pointer (needle) lighting)
Attach to included wire harness and connect to Temperature Sender (See Figure 6)
Attach to included wire harness and connect to Tachometer signal out (See Figure 9)
Note: Tie together the +12VDC
dash lighting wire (#13 white) to
the +12VDC inverter white wire
and connect to the same dash
lighting source.
(See Figure 7 for details)
Fuel Level Ground Wire (#9 Yellow/Black)
Fuel level signal (#10 Pink)
(#14 Red)
(#15 Black)
Ground
(#13 White)
Water Temperature Ground (#16 Yellow/Black)
Water Temperature Signal (#12 Yellow/Red)
Tachometer Signal (#17 Yellow Wire)
(Available on some models)
+12 volts Dash lighting (white)
(Gauge Dial lighting)
Dial Lighting Inverter Note: Single EL dial lighting inverter included with individual gauge.
Multi-gauge EL dial inverter included with gauge set of 3 to 8 gauges.
***Protect any unused connectors. Damage to an unused connector could cause inverter failure.***
left turn signal +12V pulse
right turn signal +12V pulse
high beam wire +12V
Speed signal (#2 Red/Green)
OBDII
Snap connection
Brake Light [GND] (#7 Black)
.
4X4 Indicator [GND] (#11 Orange)
Snap connection
GPS Antenna (See Figure 8)
INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING
Ground (black)
- 3 -
(#3 Green/Orange)
(#5 Green/Red)
(#1 Blue/White)
Check Engine [GND]
(#20 Purple Wire)
(Wire Pair #18 and #19)
Inverter
Snap connection for dial lighting
Advertisement
