Advertisement
BARRETT
912 Singlewire broadband dipole antenna - 125 W
1. Unpack the antenna (see unpacking instructions) and lay it out on the ground between two
mounting poles.
2. Attach rope to each insulator (one at each end) and slowly hoist between the two mounting
points (tower/poles even a tree or to the roof) ensuring the wires do not tangle. Raise to
about eye level.
3. Balun (black box) connection: Once the antenna has been raised to a convenient height,
attach the balun and coax cable as shown below. All stainless steel nuts and washers
required are provided with the balun. Remember to use the strain relief on the back of the
balun box (wrap the RG58 coax in the little "channel" under the washer and tighten the
wing nut).
4. Raise the antenna to the desired height and secure ropes. A slight curve in the antenna is
normal.
BCM91201/4
HORIZONTAL CONFIGURATION
Installation Instruction
P/N BC91201
Advertisement
