Philips AC5659 User Manual page 18

Problem
The air purifier
produces a
unpleasant smell.
The air purifier is
loud.
The air purifier still
indicates that I
need to replace a
filter, but I already
did.
Error code "E1"
displays on the
screeen.
Error codes "E2",
"E3", "E4" or "E5"
displays on the
screeen.
Which App I should
download?
EN
16
Possible solution
•
The first few times you use the appliance, it may produce
a plastic smell. This is normal. However, if the appliance
produces a burnt smell even if removing filters, contact
your Philips dealer or an authorized Philips service center.
The filter may produce smell after being used for a while
because of the absorption of indoor air. Remove the filter
and place it where it has direct sunlight and ventilation for
several hours. Re-install and try using it again. If the odor
remains, please replace the filter.
•
If the air purifier is too loud, change the fan speed to a
lower fan speed level. When using the air purifier in a
bedroom at night, choose the sleep mode.
•
Perhaps you did not reset the filter lifetime counter. Plug
in the air purifier, touch
touch and hold the reset button
Filter force reset section).
•
The hall sensor is not working properly. Remove and then
reattach the front panel. If the error code "E1" still exists,
contact the Consumer Care Center in your country.
•
The appliance has malfunctions. Contact the Consumer
Care Center in your country.
•
Download and install the Philips "Clean Home+" app from
the App Store or Google Play.
to switch on the air purifier, and
for 3 seconds (see