Canada Modem Statements（カナダ向け; 日本でのモデム規定に関する記載; New Zealand Modem Statements（ニュージーランド向け - HP 6305 SF Manual

Canada modem statements（カナダ向け）
This equipment meets the applicable Industry Canada technical specifications.
The Ringer Equivalence Number, REN, is an indication of the maximum number of devices
allowed to be connected to a telephone interface. The termination on an interface may consist
of any combination of devices, subject only to the requirement that the sum of the RENs of
all devices does not exceed 5. The REN for this terminal equipment is 1.0.
日本でのモデム規定に関する記載
コンピューターの底面に日本の認定マークが貼付されていない場合は、以下の認定マークを参照して
ください。
V.92 56K Data/Fax モデムの認証マーク：
New Zealand modem statements（ニュージーランド向け）
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network.△ It
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work correctly in all respects with
another item of Telepermitted equipment of a different make or model, nor does it imply that
any product is compatible with all of Telecom's network services.
This equipment is not capable, under all operating conditions, of correct operation at the higher
speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in
such circumstances.
If this device is equipped with pulse dialing, note that there is no guarantee that Telecom lines
will always continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other equipment,
may give rise to bell tinkle or noise and may also cause a false answer condition. Should
such problems occur, the user should not contact the Telecom Faults Service.
Some parameters required for compliance with Telecom's Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment shall
be set to operate within the following limits for compliance with Telecom's Specifications:
a. There shall be no more than 10 call attempts to the same number within any 30-minute
period for any single manual call initiation.
b. The equipment shall go on-hook for a period of not less than 30 seconds between the
end of one attempt and the beginning of the next attempt.
モデムに関するご注意
15