Factory Setups - Ecom CP 400 Operating Instructions Manual

Table of Contents

Advertisement

9. Factory Setups

The Calibrator is loaded with five factory setups. These setups are shown below.
Setup : The upper display is set to [P] mode and the middle is set to mA, lower is off.
Setup 2: The upper display is set to [P2] mode and the middle is set to mA, lower is off.
Setup 3: The upper display is set to [P] mode and the middle is set to [P2], lower is off.
Setup 4: The lower display is set to [P] switch test, the other displays are off.
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP 400 and is the answer not in the manual?

This manual is also suitable for:

Cp 420

Table of Contents