Ecom CP 400 Operating Instructions Manual page 19

Table of Contents

Advertisement

6. Use the and arrows to set the 00% point of the desired pressure range, select
DONE SET when finished.
7. Again, use the arrows to set 0% point and select DONE SET when finished and the
%ERROR mode will be ready to use.
Note: The 0% and 00% point will be saved in non-volatile memory until they are
changed again by the user for the internal sensors, and external pressure modules.
When using an external module the 0% and 00% are set to low and full scale of the
module until the user changes it, or if it was previously saved.
50

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP 400 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Cp 420

Table of Contents