Table of Contents
Advertisement
Quick Links
• Before use, always check the barrel locking nut is hand-tightened to ensure the tip is firmly held
in position.
• Regularly remove the barrel and tip to keep it clean and clear of debris. This should be done at
least once a week.
• The element is of ceramic composition which is sensitive to sharp or strong impact. Do not drop
it, or 'tap' the soldering iron in an effort to clean it. Cleaning should always be performed with a
damp sponge while the tip is hot.
Altronics Pty. Ltd. Sydney Melbourne Perth Brisbane Adelaide
7
Replacing Filter
Care & Maintenance Notice
Failure to Comply Will Void Warranty
www.altronics.com.au
2.
4.
Advertisement
Table of Contents
Related Manuals for Micron T 2444A
Summary of Contents for Micron T 2444A
- Page 1 Replacing Filter Care & Maintenance Notice • Before use, always check the barrel locking nut is hand-tightened to ensure the tip is firmly held in position. • Regularly remove the barrel and tip to keep it clean and clear of debris. This should be done at least once a week.
- Page 2 T 2444A 60W Soldering Station with Fume Extractor Operating Instructions • Continuously variable temperature control • Zero switching circuitry for spike suppression • High idle stability • Fast heat recovery • All metal construction • High performance ball bearing fan...
-
Page 3: Product Description
The high insulation of the ceramic heating element is over 100Mohm and the tip is grounded to ensure leakage is less than 0.4 millivolts. Inside the box: • T 2444A • AC Power Cord • Instruction Manual • Soldering Handle Stand Specifications: Input Power: ..................... 220-240VAC Solder Station Wattage: .................... - Page 4 Micron T 2444A Soldering Station Operating Instructions: 1 Place the soldering iron into the stand provided. 2 Plug in the power cable and slide the switch to ‘on’ position then LED lamp will be on. The extractor fan will start automatically.
- Page 5 Micron T 2444A Soldering Station Care of Tips: Important: Remove the tip and clean after every use of at least once a week, remove any loose build up in the barrel or tip to prevent tip seizing. The tips supplied are iron plated copper and if used properly will last a long time.
- Page 6 Micron T 2444A Soldering Station of the fume extractor. Follow the directions on the back page to replace the filter. Replacement filter part number: T 1291 General Cleaning: The outer case of iron or station may be cleaned with a damp cloth using small amounts of liquid detergent.
Need help?
Do you have a question about the T 2444A and is the answer not in the manual?
Questions and answers