Connect The Adapter Cables; Connect The First External Scsi Device - IBM 630-6C4 Quick Setup Instructions Manual

9

Connect the adapter cables

If you are not going to install any additional optional adapters, go to step 10.
If you are using any optional adapters (such as token ring or 8-port EIA-232), connect the
cables to the appropriate adapter connectors in the PCI slots of your system. To locate
installed adapters, consult the "About Your Machine" document.
10

Connect the first external SCSI device

If you are not going to install an external SCSI Device, go to step 11.
10.1
Connect the SCSI cable to the SCSI connector.
Connect the other end of the SCSI cable to the SCSI device.
10.2
10.3 If this is the last device connected, connect the SCSI device terminator.
If this is not the last device connected, go to the step 11.
Note: The built-in SCSI interface is Ultra3 SCSI. When a cable is not attached
to the SCSI connector on the system, the SCSI bus is automatically terminated.
To set the SCSI device address, refer to the SCSI device documentation.
10.4
Rear View
4
3
2
Rear View
1
Illustration Key
1 External SCSI Connector
2 SCSI Cable to SCSI Device
3 SCSI Terminator
4 SCSI Device