Advertisement
Important: As shown in the picture, make sure to install the stabilizer bar
as close to the top of the leg as possible, ideally, right up against the
hydraulic part of the leg. Once the stabilizer bar is secured at both ends,
repeat steps 2 and 3 for the other stabilizer bar.
⦁
Once both ends of the stabilizer bars have been secured in place, raise
the trailer up high enough so that the Kingpin Receiver Tube can be
positioned under the Kingpin Adapter. Then move the Transformer so that
the unit is in place with the Kingpin Adapter directly above the Kingpin
Adapter Receiver Tube.
Important: Before proceeding, please make sure the trailer wheels are
chocked and that the Transformer is NOT in Freewheel mode.
⦁
Slowly lower the Kingpin Adapter directly into the Kingpin Adapter
Receiver Tube.
19
Advertisement
