Adding Channels To The Tv's Memory; Programming Channels Automatically - Toshiba ColorStream TZ61V61 Owner's Manual

Adding channels to the TV's memory

Your TV will stop on specific channels that are stored in the TV's
channel memory when you press Channel y or z. Use the steps
below to set all active channels in your area automatically.

Programming channels automatically

Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory, you
can erase channels or add your favorite channels. If you use both
ANT-1 and ANT-2 terminals, you must program channels for each
input source.
To add channels:
1. Press MENU, then press x or • until the SET UP menu appears.
2. Press y or z until the TV/CABLE is highlighted.
3. Press x or • to highlight either TV or CABLE, depending on
which you use.
PICTURE AUDIO SET UP PREMIUM SBS PREFERENCE C.CAPTION
L ANGUAGE English
T V / CAB L E TV Cable
START
CH PROGRAM
PUSH
ADD / ERASE Add
ANT 1 / 2 ANT1
START
T IMER / CLOCK
PUSH
To end push EXIT
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press z to select CH PROGRAM.
5. Press x or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now Please Wait" appears.
6. When channel programming is complete, the message
"Completed (channel or cable number)" appears.
7. Press Channel y or z to view the programmed channels.
LIGHT
TV
CABLE
MUTE
VCR
1 2
4 5
7 8
0
100
FAV
18
RECALL POWER
TV/VIDEO TIMER
3
Channel yz
CH
6
9
VOL
CH RTN
ENT
ADV/
PIP CH
MENU
MENU/
FAV
ENTER
EXIT
ADV/
PIP CH