Time Display (Atv Only); Stereo And Bilingual Transmissions - Stereo/Mono Or Dual Language Broadcasts - Toshiba REGZA AV55 Digital Series User Manual

General controls, time display
stereo/bilingual transmissions
Selecting Programme Positions
To select a programme position use the numbered
buttons on the remote control.
Programme positions can also be selected using P
P .
f
To revert to the previous programme position press
To display on-screen information i.e. programme position,
channels, stereo/mono signal, signal strength, date and
time, press . Press again to cancel. The information
i +
shown will vary depending on whether the television is in
DTV or ATV mode.
Press B at any time to select between ATV and DTV
modes.

Time Display (ATV only)

The time display facility allows the current (text service)
time to be seen on the television screen.
/
Press whilst watching a normal television
8 9
broadcast to see a time display from the broadcaster. It
will remain on screen for about 5 seconds.
NOTE: This display may not always be available.
If stereo or dual language broadcasts are transmitted the
word Stereo or Dual will appear on the screen each time
programme positions are changed, disappearing after a
and few seconds. If the broadcast is not in stereo the word
e
For ATV programmes
.
^ ^
Stereo... Press
Bilingual... Bilingual transmissions are rare. If they are
transmitted the word Dual will display. Choose the
required programme number and if the word Dual
appears press
For DTV programmes
For stereo or dual mono broadcasts, press
S or R to select settings.
The settings are as follows:
16
(ATV
Stereo and Bilingual Transmissions
Mono will appear.
I/II to select Stereo or Mono.
O
I/II to select Dual 1, Dual 2 or Mono.
O
Press R for Stereo ¨ Left ¨ Right
Stereo
Press R for Dual 1 ¨ Dual 2 ¨ Dual
Dual Mono
Mono
Surround
only),
I/II and use
O