Remote Control - Teufel decoderstation 3 Technical Specifications And Operating Instructions

Function: Remote control
Test
After this button has been pressed, the de-
coder produces a test signal for equalising the
loudspeakers. The test tone is then emitted from
each loudspeaker in turn(see p. 14 – equalising
the connected loudspeakers).
Reset
Call up the decoder's factory settings using this
button. Please note: Pressing this button will
delete all of the current active settings(volume,
delay and balance)!
Centre Delay
Time delay setting options for the centre loud-
speaker(only effective in Dolby Digital/dts mode).
L(left)· R(right)· Balance
The buttons "L" and "R" reduce the respective
amounts of equalisation of the left("L") or right
("R") front loudspeakers. Pressing the "Balance"
button will return the equalisation to the original
balanced state.
Volume +/–
Increase and decrease the total volume by
individual dB. The current settings are shown in
the display on the front.
Rear Delay
Allows the time delay of the rear loudspeaker
to be set. Only works with Dolby Digital/dts and
Dolby ProLogic II.
Bypass
By pressing this button the next signal is only
emitted via the two front channels by Downmix.
The bypass can be deactivated again by selecting
another mode.
DSP mode
Allows the DSP mode for different surround
sound effects to be selected. You can scroll
through the various modes(theatre, cinema
and music) by repeatedly pressing on the "DSP"
button.
Centre
Use the[+] and[-] keys to regulate the required
levels of the centre loudspeaker. The level can be
set in steps of +/- 1dB(decibel) each.
Rear
Use the[+] and[-] keys to regulate the required
levels of the left and right rear loudspeakers. The
level can be set in steps of +/- 1dB(decibel) each.
Sub
Use the[+] and[-] keys to regulate the required
levels of the subwoofer. The level can be set in
steps of +/- 1dB(decibel) each.
Inserting or changing the batteries.
With the decoderstation 3, all of the settings
can be made simply by remote control. Activate
the decoder using the "standby" button of the
remote control. Choose the required input using
the selection buttons on the remote control.
If the appliance no longer reacts to the remote
control, even when it is used in direct proximity
to the decoder, please change the batteries.
Please note:
Do not combine new and old batteries
∂
Do not use different types of batteries
∂
Observe polarity – see markings in the battery
∂
compartment
Teufel· decoderstation 3
11