Advertisement
Quick Links
591
WELLS MANUFACTURING
265 Hobson Street, Smithville, Tennessee 37166
telephone: 314-678-6314
fax: 314-781-2714
www.wells-mfg.com
OWNERS MANUAL
HYDRO-SURGE
BUILT-IN
POT WASHER
MODEL
PW106
Includes
INSTALLATION
USE & CARE
EXPLODED VIEW
PARTS LIST
WIRING DIAGRAM
PW106
IMPORTANT: DO NOT DISCARD THIS MANUAL
This manual is considered to be part of the appliance and is to be given to the OWNER or
MANAGER of the restaurant, or to the person responsible for TRAINING OPERATORS of
this appliance. Additional manuals are available from your WELLS DEALER.
THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR
INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any
questions concerning installation, operation or maintenance of this equipment.
Z17114
04/2018
2M-
Rev. C
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Wells PW106
Summary of Contents for Wells PW106
-
Page 1: Exploded View
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment. - Page 2 Wells’ discretion have the parts replaced or codes, including incorrect gas or electrical connection. Wells is not liable repaired by Wells or a Wells-authorized service agency.
- Page 3 PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Manufacturing appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
- Page 4 FEATURES & OPERATING CONTROLS MOTOR POWER SWITCH POWER CORD IMPELLER HOUSING COVER IL1806 THUMB SCREW Fig. 1 Features and Operating Controls OVERFLOW (by others) IL1807 Fig. 2 PW-106 Operation...
- Page 5 PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only. WARNING: ELECTRIC This appliance is intended to assist in cleaning cooking utensils. No SHOCK HAZARD other use is recommended or authorized by the manufacturer or its agents.
- Page 6 INSTALLATION NOTE: DO NOT discard UNPACKING & INSPECTION the carton or other packing Carefully remove the appliance from the carton. Remove all protective materials until you have plastic film, packing materials and accessories from the Appliance inspected the appliance for before connecting electrical power or otherwise performing any hidden damage and tested it installation procedure.
- Page 7 OPERATION OPERATION CAUTION: CUT HAZARD Place items to be washed in the wash tank Fill wash tank to a depth of 10”, or up to the level of the overflow, with Impeller blades are sharp. hot tap water. DO NOT operate the unit NOTE: If using a detergent, a low-foaming detergent is recommended.
- Page 8 CLEANING INSTRUCTIONS CAUTION: PREPARATION Turn power switch OFF CUT HAZARD Unplug from electrical power Drain wash tank FREQUENCY Turn power switch OFF and Daily, or as needed disconnect unit from electric TOOLS Bottle Brush, Soft Bristle Brush power before cleaning. Soft Cloth or Sponge CAUTION: CLEANING...
-
Page 9: Troubleshooting Suggestions
TROUBLESHOOTING SUGGESTIONS SYMPTOM PROBABLE CAUSE SUGGESTED REMEDY Plug unit into appropriate receptacle Unit unplugged or circuit No power to unit breaker tripped Reset circuit breaker Power switch off Turn switch ON Internal overload tripped Allow motor to cool Unit will not run Damaged power cord Replace power cord Damaged power switch... - Page 10 EXPLODED VIEW: PW106 Model: PW106 Built-In Electric Pot Washer PL591 IL1805 Rev. B 4/01/10...
- Page 11 BOOT THREADED BLACK 2E-33192 PANEL ON & OFF SWITCH 2E-35900 SWITCH ON OFF 2U-35896 MOTOR 1/3HP 120V PW-1 2U-Z17110 MOTOR PW106 220V 50HZ 2K-31200-01 BOX CONNECTOR 3/8 2E-35539 CORD 125V 15A 5-15P 16/3 2E-35540 CORDSET 240V BAKERS K3-35897 PLATE MTG MACH PW-1...
- Page 12 NOTES:...
- Page 13 NOTES:...
- Page 14 NOTES:...
- Page 15 PARTS & SERVICE DESCRIPTION PART NO. IMPORTANT: Use only factory authorized service parts and replacement filters. The following parts are available through your Authorized Wells Service Agency: For factory authorized service, SERVICE & REPAIR or to order factory authorized IMPELLER...
- Page 16 WELLS MANUFACTURING 265 Hobson Street, Smithville, Tennessee 37166 telephone: 314-678-6314 fax: 314-781-2714 www.wells-mfg.com...
Need help?
Do you have a question about the PW106 and is the answer not in the manual?
Questions and answers