LENCO DAR-012 User Manual page 10

Setting the time
- Make sure the radio is turned off. Press and hold the "SELECT" button until "Time setup"
is shown on the display. Turn the "TUNING" knob until you see "Set Clock" and select it
by pressing the "TUNING" knob.
You can set the hour by turning the "TUNING" knob and when you have reached the
desired hour time, press the "TUNING" knob to confirm. Now you can set the minutes by
turning the "TUNING" knob again and pressing the "TUNING" knob to confirm.
Setting the date
- Make sure the radio is turned off. Press and hold the "SELECT" button until "Time setup"
is shown on the display. Turn the "TUNING" knob until you see "Set Date" and select it
by pressing the "TUNING" knob.
You can set the year by turning the "TUNING" knob and when you have reached the desired
year, press the "TUNING" knob to confirm. Then you can set the month by turning the
"TUNING" knob again and pressing the "TUNING" knob to confirm. Finally you can set the
day by turning the "TUNING" knob again and pressing the "TUNING" knob to confirm.
Change between 12/24H display
Make sure the radio is turned off. Press and hold the "SELECT" button until "Time setup" is
shown on the display. Turn the "TUNING" knob until you see "Set 12/24 hour" and select it by
pressing the "TUNING" knob. You can change between 12 and 24H clock display by turning
the "TUNING" knob and confirm by pressing the "TUNING" knob. The selection is marked
with a "*"
FAQs
Problem
No Power
No sound
Poor reception
Function disturbed
Specifications
FM Frequency range
DAB+ Frequency range
Input connector
Aerial
Mains Power
Output power
Battery Backup
Solution
Check that the system is connected to a working mains outlet.
Check that the volume control is not at minimum setting.
Adjust the position of the antenna for best signal reception.
If none of the above solution work, try unplugging your Radio or
restore to factory defaults
87.5-108MHz
174.9-239.2MHz
AUX in (R/L) RCA socket
Telescopic antenna
AC 230 ~50Hz
2 x 5W RMS
2 x AAA 1, 5V
10