Specific Safety Rules - Promax FP-2b User Manual

USER'S MANUAL FP-2b

3.2 Specific safety rules

∗ When measuring resistances take care that circuit under test
is not powered.
∗ When measuring currents disconnect the power supply of the
circuit under test before inserting the multimeter in series.
∗ When measuring currents, be sure that points under test do
not exceed the maximum voltage.
∗ Keep measuring leads in good condition.
∗ Between measurements higher than 10 A which extend near
to the maximum time specified, keep waiting times of about
10 minutes.
∗ Before rotating the range selector, disconnect the test leads
from the circuit under test.
∗ When measuring
previously discharged.
Disconnect the test leads before inserting transistors or
∗
capacitors in their respective sockets.
Page 10
capacities, be sure capacitors
Janvier 2001
are