Connecting A Dtv Receiver/Set-Top Box (With Or Without Colorstream™) And A Vcr - Toshiba 43H70 Owner's Manual

Connecting a DTV receiver/set-top box
(with or without ColorStream™) and a VCR
This connection allows you to watch DTV (digital TV broadcast),
VCR, and TV programs, and record DTV and TV programs. You
can record from one source while watching a program from another
source.
Your TV has ColorStream component video inputs. Connecting your
TV to a ColorStream-compatible DTV receiver can greatly enhance
picture quality and realism.
You will need:
• one coaxial cable
• three pairs of audio cables (two single and one pair of audio
cables for a mono VCR)
• two video cables
• one set of ColorStream video cables (one S-video cable for a
non-ColorStream DTV receiver; see notes at right)
Stereo VCR
From
Antenna
IN from ANT OUT to TV
TV
S-VIDEO
VIDEO
L/
MONO
AUDIO
R
VIDEO-1 VIDEO-2
IN
From
DTV
Antenna
Satelite IN
S-VIDEO
DTV Receiver with ColorStream™
VIDEO AUDIO
L R
IN
CH 3
OUT
CH 4
AUDIO CENTER
CHANNEL IN
ANT( 75
ANT-1
ON OFF
OUT
OUT
VAR
R L
AUDIO
VIDEO
Y Y
ANT-2
L/
L MONO L
P P
B B
AUDIO
P P
R R
R R R
COLOR COLOR
STREAM AUDIO AUDIO STREAM
HD 1 HD 2
IN OUT IN
AUDIO
OUT
L L
Y C C
B R
R R
COMPONENT VIDEO VIDEO
OUT
Note:
For the highest possible picture quality, you
must use ColorStream video cables between
the TV and DTV receiver. You can connect the
ColorStream cables from the DTV receiver to
either ColorStream jack on the TV (HD1 or
HD2).
The ColorStream HD1 and HD2 jacks can
be used with Progressive (480p) and
Interlace (480i, 1080i) scan systems. If you
receive the 1080i source, you may need to
change the picture size (see "Selecting 1080i
picture size" on page 34).
If your DTV receiver is not ColorStream-
compatible, use the S-video connections
(both audio and video) instead of the
ColorStream connections. (Be aware,
however, that a ColorStream connection
provides higher picture quality than an
S-video connection.) Do not connect both
S-Video and ColorStream cables between the
TV and DTV receiver at the same time.
To record from the DTV receiver, set the VCR
to Line IN. To monitor recording from the DTV
receiver, set the VCR to Line IN, and set the
TV to Video-1.
Caution:
The unauthorized recording of television
programs, videotapes, and other materials
)
may infringe upon the provisions of copyright
laws.
9