Table of Contents
Advertisement
MAST ASSEMBLY
To insert the mast, remove the
mast cover cap. Unplug the black
wire in the base. Then connect
both the black and white wires to
the wires inside the bottom section
of the mast. Slide the mast into the
platform.
Be careful not to catch the wires
during assembly.
www.PyleUSA.com
Secure the bottom tube of the
mast by screwing in place with 3
x bolts and allen key provided.
Hand screws are provided for
quick and easier assembly.
Insert the top section of the mast
securing the wires inside the
tubes frst. then slid the tube into
the bottom section of the mast.
Secure in place by using the
hand screw provided. This can be
adjusted afterwards for the
optimal height.
10
Attach the display and handlebar
with pulse sensors by connecting
the wire in the mast to the wire
on the back of the display. Then
slide on to the top of the mast.
Secure in place using the hand
screw provided.
The platform can be used without
the mast if you wish. Use the cap
to cover the hole where the mast
goes to avoid damage
SETTINGS AND USE
Turn the machine on by ensuring
the supplied power cord is
plugged in to the machine frst
then plugged in to a suitable
power socket and turning the
power switch on the rear of the
machine to the "I" position
ensuring the switch illuminates.
The display will show dashes
across the board. Then press the
power button on either the
display unit.
This will automatically be in
manual mode with 10 minutes
set. Select your desired
programme and then press play.
At the end of your workout. to
turn off the machine press the
power button on the display
and then press the switch at the
back of the machine and
unplug from the mains supply.
11
www.PyleUSA.com
Advertisement
Table of Contents
