Download Print this page

Connection To The Mains Supply - Breville VFM021 Manual

Hand mixer with heatsoft technology
Hide thumbs Also See for VFM021:

Advertisement

recipes
Chocolate Chip Cookies
Makes: 30 cookies
150g chilled butter, cubed
125g soft light brown sugar
100g caster sugar
2 tsp vanilla extract
1 medium egg yolk
1 medium egg
300g plain flour
1 tsp bicarbonate of soda
200g milk chocolate chips
1.
Preheat oven to 170˚C (150˚C fan). Line 2 baking sheets with greaseproof paper.
2.
Add butter into a bowl with both sugars.
3.
Press HeatSoft
TM
button and mix on speed 1 until combined and softened, then
increase the Speed to 7 for approximately 2 minutes.
4.
Turn off HeatSoft
.
TM
5.
Add vanilla, eggs and mix until light and creamy.
6.
Slowly mix in flour and bicarbonate of soda until just blended, then fold in chocolate
chips.
7.
Roll 2 level tablespoonfuls of mixture into balls and place on prepared trays, 3cm
apart. Press down slightly.
8.
Place the trays into oven and bake for approximately 15 minutes. Allow to cool for a
few minutes on the tray before removing to a wire rack.
15

connection to the mains supply

This appliance is fitted with either a moulded or rewirable BS1363, 13 amp plug. The fuse
should be rated at 3 amps and be ASTA approved to BS1362.
If the fuse in a moulded plug needs to be changed, the fuse cover must be refitted. The
appliance must not be used without the fuse cover fitted.
If the plug is unsuitable, it should be dismantled and removed from the supply cord
and an appropriate plug fitted as detailed below. If you remove the plug it must not be
connected to a 13 amp socket and the plug must be disposed of immediately.
The wires of the mains lead are coloured in accordance with the following code:
BLUE – NEUTRAL
The wire which is coloured Blue, must be connected to the terminal which is marked with
the letter N or coloured Black.
The wire which is coloured Brown, must be connected to the terminal which is marked
with the letter L or coloured Red.
If any other plug is used, a 3 amp fuse must be fitted either in the plug or adaptor or at the
distribution board.
CAUTION: DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL IN THE
PLUG WHICH IS MARKED E OR WITH THE EARTH SYMBOL ( ) OR COLOURED
GREEN OR GREEN AND YELLOW.
This symbol indicates that this unit is a Class II appliance and therefore an earth
connection is not required.
Plug should be BS1363/A approved
Fit a 3 Amp Fuse
BLUE
(Neutral)
Ensure that the outer sheath of the cable
is firmly held by the clamp
BROWN – LIVE
3 Amp Fuse
BROWN
(Live)
16

Advertisement

loading