Advertisement
Cable Strain Relief Kit
DXE-CSR8X-1
DXE-CSR213-1
DXE-CSR8X/213-1-INS Rev 2d
DXE-CSR8X-1 shown installed with a typical DX Engineering Balun (left picture)
DXE-CSR213-1 shown installed on a typical Comtek Balun (right picture)
(Additional optional parts shown)
© DX Engineering 2017
1200 Southeast Ave. - Tallmadge, OH 44278
Phone: (800) 777-0703 ∙Tech Support and International: (330) 572-3200
Fax: (330) 572-3279 ∙E-mail: DXEngineering@DXEngineering.com
- 1 -
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DX Engineering DXE-CSR8X-1
Summary of Contents for DX Engineering DXE-CSR8X-1
- Page 1 Cable Strain Relief Kit DXE-CSR8X-1 DXE-CSR213-1 DXE-CSR8X/213-1-INS Rev 2d DXE-CSR8X-1 shown installed with a typical DX Engineering Balun (left picture) DXE-CSR213-1 shown installed on a typical Comtek Balun (right picture) (Additional optional parts shown) © DX Engineering 2017 1200 Southeast Ave. - Tallmadge, OH 44278 Phone: (800) 777-0703 ∙Tech Support and International: (330) 572-3200...
- Page 2 The DX Engineering DXE-CSR8X-1 and DXE-CSR213-1 are coaxial Cable Strain Relief kits especially designed to be used with DX Engineering Baluns and Comtek Baluns. The Cable Strain Relief may also be used on other baluns using the same NEMA grey case used on the Comtek Baluns.
- Page 3 Figure 1 Figure 2 Fully insert the PL-259 to the balun and tighten the collar. Loop the cable through the ‘P’ clamps and form approximately a 6” diameter loop of cable. Mount the ‘P’ clamps on both sides of the bracket using the hardware (1”...
-
Page 4: Technical Support
Warranty All products manufactured by DX Engineering are warranted to be free from defects in material and workmanship for a period of one (1) year from date of shipment. DX Engineering’s sole obligation under these warranties shall be to issue credit, repair or replace any item or part thereof which is proved to be other than as warranted; no allowance shall be made for any labor charges of Buyer for replacement of parts, adjustment or repairs, or any other work, unless such charges are authorized in advance by DX Engineering.
Need help?
Do you have a question about the DXE-CSR8X-1 and is the answer not in the manual?
Questions and answers