* PROTECTI ON*
LAMP(Inverter) PROTECION
If the lamp connector is disconnected or there is no feedback because the lamp
has a crack, the lamp protection is activated.
If the Inverter Trans has a high voltage output, the Over Voltage Protection is activated
as lamp protection.
Power Protection
All protections (OVP/OCP) for the panel operate in Auto Recovery Mode.
Therefore, when a protection is activated temporarily, the panel continues to work without
power- off when it is cleared.
However, exceptionally, in the case of Thermal Protection, the panel works normally only
if the power is turned off to discharge completely and turned on again. This is controlled by
the function designed in the Power IC.