Your TV remote control may not operate certain features
•
on your external device. Refer to the owner's manual for
your other device to determine its available features. If
your TV remote control does not operate a specific
feature on another device, use the remote control that
came with the device (- pages 27–35).
If the TV still does not act as expected, use the Reset
•
Factory Defaults procedure (- page 44).
Channel tuning problems
Make sure the remote control is set to the correct device
•
mode (- page 24).
The channel may have been erased from the channel
•
memory by the Channel Add/Delete feature. Add the
channel to the channel memory (- page 40).
•
The channel may be blocked by the Channels Block
feature. Unblock the channel (- page 62).
•
If you are unable to tune digital channels, check the
antenna configuration (- page 39). If you are still
unable to tune digital channels, clear all channels from
the channel list (- page 41) and reprogram channels
into the channel memory (- page 40). If you are still
unable to tune digital channels, use the Reset Factory
Defaults procedure (- page 44). Also see "TV stops
responding to controls" and "Other problems"
(- page 75).
Closed caption problems
•
If the program or video you selected is not closed-
captioned, no captions will display (- page 56).
•
If text is not available, a black rectangle may appear.
If this happens, turn off the closed caption feature (-
page 56).
A closed-caption signal may not display correctly in the
•
following situations: a) when a videotape has been
dubbed; b) when the signal reception is weak; or c) when
the signal reception is nonstandard (- page 56).
Rating blocking (V-Chip) problems
•
If you forget your PIN code: While the PIN code entering
screen is displayed, press E four times within 5
seconds. The PIN code you previously stored will be
cleared (- page 60).
The V-Chip feature is available for the U.S. V-Chip
•
system only (- page 61).
No CE-Link operation
•
The CE-Link feature is available for Toshiba CE-Link
compatible devices.
•
Make sure the HDMI cables with the HDMI Logo
(
) are used.
When the connected CE-Link device does not work
•
correctly after you have changed settings of the device,
turn off your TV and unplug the power cord, then plug
and turn on again.
If several devices are connected, CE-Link feature may
•
not operate properly.
Read the instruction manual furnished with the connected
•
CE-Link device.
76
Chapter 8: Troubleshooting
HDMI problems
For HDMI cables
Make sure to use cables with the HDMI Logo
•
(
For Legacy HDMI source
Some legacy HDMI sources may not work properly with
•
the latest HDMI TV products, due to new standard
adoption. Unplug your HDMI cable first and then try
turning Off the HDMI settings (Lip-Sync Latency,
xvYCC) and your legacy HDMI source should operate
properly with this TV (- page 68).
) (- page 19).