Selecting The Color Temperature; Using Cableclear ® Digital Noise Reduction - Toshiba Regza 40RF350U Owner's Manual

Selecting the color temperature

You can change the quality of the picture by selecting from
three preset color temperatures (Cool, Medium, and Warm), as
described below.
Mode Picture Quality
Cool blueish
Medium neutral
Warm reddish
To select the color temperature:
Press Y and open the Video menu.
1
Highlight Picture Settings and press T.
2
Highlight Advanced Picture Settings and press T.
3
Highlight Color Temperature and press T.
4
Advanced Picture Settings
Dynamic Contrast
Static Gamma
Color Temperature
Reset
5
In the Color Temperature field, select the mode you
prefer (Cool, Medium, or Warm).
Color Temperature
Color Temperature
B Drive
G Drive
Reset
6
Press B or b to select either B Drive or G Drive, and
then press C or c to adjust the settings.
B Drive
G Drive
B Drive: c makes the picture blueish.
•
G Drive: c makes the picture greenish.
•
Note: The B Drive and G Drive settings are connected to
the Color Temperature settings and will change based
on which setting is selected in step 5 above.
To save the new settings, highlight Done and press T.
7
To revert to the factory defaults, highlight Reset and
press T.
Note: If you select one of the factory-set picture modes
(Sports, Standard, Movie, or Document) and then
change the color temperature mode, the picture mode
automatically changes to Preference.
Chapter 7: Using the TV's advanced features
Mode: Preference
High
0
Cool
Done
Mode: Preference
Cool
0
0
Done
1
1
®
Using CableClear digital noise reduction
The CableClear ® digital noise reduction feature allows you to
reduce visible interference in your TV picture. This may be
useful when receiving a broadcast with a weak signal
(especially a Cable channel) or playing a noisy video cassette
or disc.
To change the CableClear settings:
Press Y and open the Video menu.
1
Highlight Noise Reduction and press T.
2
Video
Mode
Picture Settings
Noise Reduction
ColorMaster
xvYCC Selection
Game Mode
Theater Settings
TheaterLock
3
In the CableClear field, select your desired setting.
Noise Reduction
CableClear
MPEG Noise Reduction
Reset
Note:
• If the current input is ANT, VIDEO 1, or VIDEO 2, the
menu will display the text "CableClear." The available
selections are Off, Auto, Low, Middle, and High.
• If the current input is ColorStream HD1, ColorStream
HD2, HDMI 1, HDMI 2, or HDMI 3, the menu will display
the text "DNR." The available selections are Off, Auto,
Low, Middle, and High. Auto will react proportionally
to the strength of the noise. Low, Middle, and High will
reduce the noise in varying degrees, from lowest to
highest, respectively.
To save the new settings, highlight Done and press T.
4
To revert to the factory defaults, highlight Reset and
press T.
Sports
Auto
Off
Off
ANT
Auto
Low
Done
71