Adjusting The Picture; Selecting The Picture Mode; Adjusting The Picture Quality - Toshiba Regza 26HL67 Owner's Manual

Adjusting the picture

Selecting the picture mode

You can select your desired picture settings from four different
modes, as described below.
Mode Picture Quality
Sports Bright and dynamic picture (factory setting)
Standard Standard picture settings (factory setting)
Lower contrast for darkened room (factory
Movie
setting)
Preference Your personal preferences
To select the picture mode:
Press u on the remote control.
The following popup menu appears on-screen.
Sports
Standard
Movie
Preference
Press B or b to select the picture mode you prefer and
press T.
To select the picture mode using the menu system:
1
Press Y and open the Video menu.
2
Highlight Mode and press T.
Video
Mode
Picture Settings
Noise Reduction
Game Mode
Theater Settings
3
Press B or b to select the picture mode you prefer and
press T.
Sports
Standard
Movie
Preference
Note: The picture mode you select affects the current
input only. You can select a different picture mode for
each input.
42
Chapter 6: Using the TV's features
Sports
Off

Adjusting the picture quality

You can adjust the picture quality (Contrast, Back Light,
DynaLight™, Brightness, Color, Tint, and Sharpness) to your
personal preferences.
Pressing C
Selection
Contrast lower
Back Light* darker
DynaLight** On/Off
Brightness darker
Color paler
Tint reddish
Sharpness softer
* Back Light
This feature adjusts the brightness of the entire screen. When in
video mode and no signal is input, this will automatically be set to 0.
(Settings are stored in memory.)
**DynaLight
This function automatically strengthens the black coloring of dark
areas in the video according to the level of darkness.
To adjust the picture quality:
1
Press Y and open the Video menu.
2
Highlight Picture Settings and press T.
3
Press B or b to select the picture quality you want to
adjust (Contrast, Back Light, DynaLight,
Brightness, Color, Tint, or Sharpness), and then
press C or c to adjust the setting, as described in the table
above.
Picture Settings
Contrast
Back Light
DynaLight
Brightness
Color
Tint
Sharpness
Advanced Picture Settings
Reset
Picture Settings
Contrast
4
To save the new settings, highlight Done and press T.
You can use any of the picture modes (- "Selecting the
picture mode," above left) as a starting point for adjusting
the picture settings.
To revert back to the base mode that you began adjusting
the picture settings from, highlight Reset and press T.
The picture qualities you adjusted are automatically saved in
the Preference mode (- "Selecting the picture mode,"
above left) until Reset is selected.
Pressing c
higher
lighter
On/Off
lighter
deeper
greenish
sharper
Mode: Sports
100
100
On
50
50
0
50
Done
Mode: Preference
70