Table of Contents
Advertisement
A wide variety of external equipment can be connected via the sockets located on the side of the TV.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the buttons on
the TV may be used for some functions.
Switching on
If the power-on light is unlit check the adaptor is
connected and the power switched on.
To put the set into Standby press
control. To view the TV press
take a few seconds to appear. Standby should only be
used for short periods of time.
To set up the TV you will now need to use the on-screen
menus. Press the MENU button on the remote control to
see the menus.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing the S or R button on the remote
control, its respective options will appear below.
To use the options press the Q button on the remote
control to move down through them and S or R to select
the required choice or adjust a setting. The functions of
each menu are described in detail throughout the
manual.
Connections and controls
on the remote
i
again. The picture may
i
Using the controls and connections
To alter the volume press —
To alter the programme position press
When connecting mono sound equipment to EXT2,
connect the audio output of the equipment to the
L(Mono) socket on the TV.
To select the Input, press
EXT1 as described on page 10. The TV will automatically
sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
7
Standby Button
RED – Standby
Green – On
+
.
j
e e
F
B
until the display shows
f f
.
Advertisement
Table of Contents
