Table of Contents
Advertisement
Manual and Automatic Fine Tuning
(MFT/AFT), general controls, input selection
Manual Fine Tuning (MFT)
Manual Fine Tuning (MFT) should not be required
unless interference is experienced or the signal is weak.
View the the programme position to be fine tuned
1
using the P
( P ) and P
f
Press MENU and select the SET UP menu. Use
P or Q to highlight MFT.
SET UP
f
SKIP
MFT
AFT
Press S or R and hold until the best picture and
2
sound are obtained. While the TV is fine tuning
or
will flash. Press EXIT.
z
x
PLEASE NOTE: Automatic Fine Tuning (AFT) is
automatically set to OFF whilst the TV is manually
fine tuning.
Automatic Fine Tuning (AFT)
Automatic Fine Tuning (AFT) automatically corrects
slight fluctuations in the broadcast signal.
View the the programme position to be fine tuned
1
by selecting with the P
buttons.
Press MENU and select the SET UP menu. Use
P or Q to highlight AFT.
SET UP
f
SKIP
MFT
AFT
Press S or R to select ON. Press EXIT.
2
(Q) buttons.
e
z
OFF
x
z x
z
OFF
x
( P ) and P
(Q)
f
e
z
OFF
x
z x
z
ON
x
Selecting programme positions
To select a programme position use the numbered
buttons on the remote control.
For programme positions below 10 use 0 and the
required number e.g. 01 for programme position 1.
Programme positions can also be selected using P
and P
(Q).
e
To revert to the previous programme position press
To display on-screen information i.e. programme position,
input mode or stereo/mono signal, press CALL.
Stereo and Bilingual transmissions
If stereo or dual language broadcasts are transmitted the
word Stereo or Dual will appear on the screen each time
programme positions are changed, disappearing after a
few seconds. If the broadcast is not in stereo the word
STEREO... Press
BILINGUAL... Bilingual transmissions are rare. If they are
transmitted the word DUAL will display. Choose the
required programme number and if the word DUAL
appears press
O
MONO.
Use the Input Selection to view connected equipment if the
TV does not switch over automatically.
Press
B
1
EXT1:
B
terminals on the back of the TV.
EXT2:
B
terminals on the sides of the TV.
To return to TV mode press
2
the numbered buttons.
10
Mono will appear.
to select STEREO or MONO.
I/II
O
to select DUAL 1, DUAL 2 or
I/II
Input selection
to select EXT1 or EXT2.
1 displays equipment connected to the
2 displays equipment connected to the
again or one of
B
( P )
f
.
^ ^
Advertisement
Table of Contents
