Sony NSBK-DH05 Installation Manual page 8

6
Remove the protective cover for
monitor connector 2.
If secured by screws
Use a Phillips screwdriver to remove
the two screws securing the protective
cover.
If not secured by screws
Push in the protective cover from the
outside of the unit with a screwdriver,
for example.
7
Remove the two hex cap screws on the
supplied RGB cable.
8 Step 1: Installing the Display Accelerator Board on the NSR-500
8
Pass the 15-pin D-sub connector
through the slot for monitor connector
2 from the inside of the unit, and secure
the two hex cap screws to the
connector from the outside of the unit.