Mounting The Right Support Legs To The Barrel; Assembling The Bottom Shelf; Mounting The Wheels - Cabela's PRO Series Instructions And Recipes Manual

2. MOUNTING THE RIGHT SUPPORT LEGS TO THE BARREL

Parts Required:
2 x Support Leg For Wheel (#18)
6 x Screw (#A)
Locking Washer (#C)
6 x
Washer (#B)
6 x
Installation:
• Assemble one support leg for wheel onto the main barrel (closest to the
floor/cardboard). Install two washers, locking washers, and screws from
the outside of the main barrel, towards the inside. Note illustration 2A.
Next, install one washer, locking washer, and screw from the inside of
the main barrel, towards the outside, on the same support leg. Note
illustration 2B.
• Repeat same installation for other support leg for wheel. Note illustration 2B.

3. ASSEMBLING THE BOTTOM SHELF

Parts Required:
Bottom Shelf (#20)
1 x
Screw (#A)
4 x
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• Attach the bottom shelf using a washer, locking washer, and screw on
each of the four support legs.
IMPORTANT: The flat surface of the bottom shelf should face the
main barrel. Take care not to install the bottom shelf upside-down.

4. MOUNTING THE WHEELS

Parts Required:
2 x Locking Caster Wheel (#15)
Wheel (#16)
2 x
Wheel Axle Pin (#F)
2 x
4 x Wheel Washer (#E)
2 x Wheel Axle Nut (#D)
Installation:
• Insert one of the pre-threaded locking caster wheels into the bottom
of a support leg by hand-tightening it into the hole. Ensure the locking
caster wheel is inserted completely. Continue to install the other caster
wheel to the other support leg.
IMPORTANT: Lock caster wheels before lifting grill upright.
• Attach the wheel to the support leg by inserting the wheel axle pin
through the wheel, add a wheel axle washer, then insert through the
support leg. Secure the wheel axle pin by adding another wheel axle
washer, then the wheel axle nut. Repeat installation for the other wheel
to the final support leg.
NOTE: Once all wheels are mounted, the two locking caster wheels
2A
2B
3A
4
7