Toyota Yaris Manual page 225

NOTICE
■ Front sensor
Observe the following to ensure that the sensor operates correctly:
●
Do not attach stickers, including trans-
parent stickers, or other items to the
outer side of the windshield in front of
the front sensor (shaded area in the
illustration).
A: From the top of the windshield to
approximately 10 cm (4.0 in.) below the
bottom of the front sensor
B: Approximately 20 cm (7.9 in.) (Approximately 10 cm (4.0 in.) to the
right and left from the center of the front sensor)
●
Do not install or attach anything to the
inner side of the windshield under the
front sensor (shaded area in the illustra-
tion).
A: Approximately 10 cm (4.0 in.) (Starting
from the bottom of the front sensor)
B: Approximately 20 cm (7.9 in.) (Approx-
imately 10 cm (4.0 in.) to the right and left
from the center of the front sensor)
●
Do not attach window tinting to the windshield.
●
If the part of the windshield in front of the front sensor is fogged up or cov-
ered with condensation or ice, use the windshield defogger to remove the
fog, condensation or ice.
● Keep the windshield clean at all times.
The pre-crash safety system may not function properly if the windshield is
dirty or covered with an oily film, water droplets, snow, etc.
If the inner side of the windshield where the front sensor is installed is dirty,
do not attempt to remove the front sensor. Contact any authorized Toyota
dealer or repairer, or another duly qualified and equipped professional.
●
If the windshield needs to be replaced, contact any authorized Toyota
dealer or repairer, or another duly qualified and equipped professional.
●
Do not install an antenna in front of the sensor.
●
Do not spill liquid onto the sensor.
●
Do not allow bright lights to shine into the sensor.
●
Do not damage or let the lenses of the front sensor get dirty.
When cleaning the inner side of the windshield, do not let glass cleaner
contact the lenses. Also, do not touch the lenses.
For proper care of the lenses of the front sensor, contact any authorized
Toyota dealer or repairer, or another duly qualified and equipped profes-
sional.
●
Do not change the installation position or direction of the sensor or remove
it. The direction of the sensor is precisely adjusted.
●
Do not subject the sensor to strong impact or disassemble it.
●
Do not install an electronic device or device that emits strong electric
waves near the front sensor.
●
Do not place reflective objects on top of the instrument panel.
YARIS_F_WE_52F20E
4-5. Toyota Safety Sense
225
4