Table of Contents
Advertisement
Stop/Start
The Stop/Start system shuts off the engine
when the vehicle speed is 0 mph (0 km/h), as
a fuel conservation measure.
In order to maintain comfort in the cabin, the
Stop/Start feature will not activate if any of the
following conditions exist:
The climate control system is in AUTO mode
(indicator illuminated), and the vehicle has
yet to reach the set temperature
The climate control system is in LO
maximum cooling
The climate control system is in HI
maximum heating
The climate control system is in the
MAX-DEF status
When the Stop/Start system is active, the
engine will restart if the inside temperature
changes significantly, or if the LO setting, or
MAX-DEF setting, is activated.
With Stop/Start system on (engine is OFF), air
flow is reduced to keep the compartment
comfort conditions for longer.
Until the temperature drastically changes within
the cabin, the climate control system will
continue to maintain the temperature while the
engine is off. By deactivating the Stop/Start
system with the
button (located by the head-
light switch), the climate control system operates
normally according to the settings.
52
NOTE:
In harsh climate conditions, limit the use of
the Stop/Start system to prevent the
compressor from continuously switching on
and off. This will prevent rapid misting of the
windows and the accumulation of humidity
in the passenger compartment.
When the Stop/Start system is on, the
climate control system will always take air in
from outside, reducing the probability of the
windows fogging up.
System Maintenance
In winter, the Climate Control System must be
turned on at least once a month for approxi-
mately ten minutes.
Have the system inspected at an authorized
dealer before the summer.
POWER WINDOWS
Power Window Switches
The power window switches work with the igni-
tion in the ACC or ON/RUN position and for
three minutes after the ignition has been
placed in the OFF position. When one of the
front doors is opened, this operation is
disabled.
Driver Side Front Door Controls
The switches are located on the door panel
trim. All windows can be controlled from the
driver side door panel.
Power Window Switches
1 — Front Left Window Switch
2 — Front Right Window Switch
3 — Rear Right Window Switch
4 — Window Lockout Switch
5 — Rear Left Window Switch
Window Opening
Push the buttons to open the desired window.
Each button has two position steps. Push
gently, without going past the detent for
manual window operation, while pushing the
same button harder, past the detent, activates
"continuous automatic" operation.
If the button is pushed again, the window will
stop in the desired position.
Advertisement
Table of Contents
