Table of Contents
Advertisement
WARNING! (Continued)
• If the tire has any sidewall damage.
• If the tire has any damage from driving
with extremely low tire pressure.
• If the tire has any damage from driving
on a flat tire.
• If the wheel has any damage.
• If you are unsure of the condition of
the tire or the wheel.
Keep Tire Service Kit away from open
flames or heat sources.
A loose Tire Service Kit thrown forward in
a collision or hard stop could endanger
the occupants of the vehicle. Always stow
the Tire Service Kit in the place provided.
Failure to follow these warnings can result
in injuries that are serious or fatal to you,
your passengers, and others around you.
Take care not to allow the contents of Tire
Service Kit to come in contact with hair,
eyes, or clothing. Tire Service Kit sealant is
harmful
if
inhaled,
swallowed,
absorbed through the skin. It causes skin,
eye, and respiratory irritation. Flush imme-
diately with plenty of water if there is any
contact with eyes or skin. Change clothing
as soon as possible, if there is any contact
with clothing.
WARNING! (Continued)
Tire Service Kit Sealant solution contains
latex. In case of an allergic reaction or
rash, consult a physician immediately.
Keep Tire Service Kit out of reach of chil-
dren. If swallowed, rinse mouth immedi-
ately with plenty of water and drink plenty
of water. Do not induce vomiting! Consult
a physician immediately.
To use your Tire Service Kit, proceed as
follows:
1. Apply the electric park brake.
2. Insert the sealant cartridge containing the
sealing fluid in the proper compressor
holder, pushing down hard. Unscrew the
tire valve cap, take out the filler tube and
tighten the fitting on the tire valve.
or
Attaching Filler Tube To Deflated Tire
1 — Sealant Cartridge
(Continued)
2 — Filler Tube
3. Make sure the power switch of
the compressor is in the O (off) position.
4. Insert the plug into the power outlet in
the center console, then start the engine.
Center Console Power Outlet
5. Start the compressor by placing the
power switch in the I (on) position.
6. Inflate the tire to the pressure indicated
on the tire placard, located on the
driver's side B-Pillar or the rear edge of
the driver's side door. Refer to "Tires"
in "Servicing And Maintenance" for
more information. In order to obtain a
more precise reading,
213
Advertisement
Table of Contents
