Alfa Romeo Giulia 2020 Owner's Manual page 129

NOTE:
After an accident, remember to cycle the igni-
tion to the OFF position and remove the key
from the ignition switch to avoid draining the
battery. Carefully check the vehicle for fuel
leaks in the engine compartment and on the
ground near the engine compartment and fuel
tank before resetting the system and starting
the engine. If there are no fuel leaks or
damage to the vehicle electrical devices (e.g.
headlights) after an accident, reset the system
Customer Action
1. Turn ignition OFF. (Turn Signal Switch Must be placed in
Neutral State).
2. Turn ignition ACC/ON/RUN.
3. Turn right turn signal switch ON.
4. Place turn signal in neutral state.
5. Turn left turn signal switch ON.
6. Place turn signal in neutral state.
7. Turn right turn signal switch ON.
8. Place turn signal in neutral state.
by following the procedure described below. If
you have any doubt, contact an authorized
dealer.
Enhanced Accident Response System
Reset Procedure
After the event occurs, when the system is
active, a message regarding fuel cutoff is
displayed. Turn the ignition switch from igni-
tion ACC or ON/RUN to ignition OFF. Carefully
check the vehicle for fuel leaks in the engine
NOTE:
Each step MUST BE held for at least two seconds
compartment and on the ground near the
engine compartment and fuel tank before
resetting the system and starting the engine.
Depending on the nature of the event the left
and right turn signal lights, located in the
instrument panel, may both be blinking and
will continue to blink. In order to move your
vehicle to the side of the road, you must follow
the system reset procedure.
Customer Will See
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS.
Right turn light BLINKS.
Left turn light is ON SOLID.
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS.
127