Specifications - LG LPC-140A Owner's Manual

Specifications

SECTION
Power supply
Power consumption
Mass
External dimensions (W x H x D)
Output Power
Speakers
Battery Operation
Frequency response
Signal-to-noise ratio
T.H.D
Tuning Range
Intermediate Frequency
Antenna
Tuning Range
Intermediate Frequency
Antenna
Recording System
Frequency Response
Signal to Noise Ratio
Designs and specifications are subject to change without notice for improvement.
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon a
dedicated circuit;
That is, a single outlet circuit which powers only that
appliance and has no additional outlets or branch circuits.
Check the specification page of this owner's manual to be
certain.
Do not overload wall outlets. Overloaded wall outlets, loose
or damaged wall outlets, extension cords, frayed power
cords, or damaged or cracked wire insulation are
dangerous. Any of these conditions could result in electric
shock or fire. Periodically examine the cord of your
appliance, and if its appearance indicates damage or
deterioration, unplug it, discontinue use of the appliance,
and have the cord replaced with an exact replacement part
by an authorized servicer.
Protect the power cord from physical or mechanical abuse,
such as being twisted, kinked, pinched, closed in a door, or
walked upon. Pay particular attention to plugs, wall outlets,
and the point where the cord exits the appliance.
MODEL
LPC-140A
Refer to the back panel of the unit.
10W
3.0 kg
300 x 252 x 171 mm
1W X 2 T.H.D 10%
8Ω X 2
DC 9V, six "C"(R14) batteries (not supplied)
100 - 18000 Hz
55 dB
0.5 %
87.5 -108 MHz
10.7 MHz
Telescopic antenna
522 - 1611 kHz or 530 - 1610 kHz
455 kHz
Ferrite bar antenna
4 Tracks 2 channel stereo
125 - 8000Hz
35/40dB (REC/PLAY)
POWER: This unit operates on a mains supply of 220V,
50Hz.
WIRING: This unit is supplied with a BSI 1363 approved 13 amp
mains plug, fused at 3 amp. When replacing the fuse always use a 2.5
amp BS 1362, BSI or ASTA approved type. Never use this plug with
the fuse cover omitted. To obtain a replacement fuse cover contact
your dealer. If the type of plug supplied is not suitable for the mains
sockets in your home, then the plug should be removed and a suit-
able type fitted. Please refer to the wiring instructions below:
WARNING: A mains plug removed from the mains lead of this
DVD player must be destroyed. A mains plug with bared wires is
hazardous if inserted in a mains socket.
Do not connect either wire to the earth pin, marked with the letter E
or with the earth symbol or coloured green or green and yellow.
If any other plug is fitted, use a 2.5 amp fuse, either in the plug, or at
the distribution board.
IMPORTANT: The wires in this mains lead are coloured in accor-
dance with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the wires
in the mains lead of this DVD player may not correspond with the
coloured marking identifying the terminals in your plug, proceed as
follows: The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black. The
wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
LPC-140X
87.5 -108 MHz/65 -108 MHz
11