Table of Contents
Advertisement
3.2.3 C
ONNECTING THE
1. Using the ServSwitch unit's HD15 cable (EHN70045), connect the HD15
KVM connector to the PC1 HD15 port on the back of the ServSwitch. See
Figure 3-3. Connect the two audio connectors (follow the PC99 color codes)
to the corresponding ports on the back of the ServSwitch.
HD15
computer
Figure 3-3. Connecting the computer, speakers, and microphone.
2. Connect the male VGA connector to the corresponding female VGA port on
the back of the computer. Connect the two 6-pin mini-DIN connectors to the
keyboard and mouse connectors on the back of the PC. Connect the audio
(speakers) connector and the microphone connector (follow the PC99 color
codes) to the back of the PC. (Refer to Figure 3-3.)
3. Repeat steps 1 and 2 for all computers.
4. Power on your computers. Your computers' operating systems should
recognize the ServSwitch and will automatically install the HD15 driver if it
was not already installed on your computers.
C
OMPUTERS
(2) 6-pin mini-DIN
connectors for keyboard
and mouse ports
Microphone
Speaker
CHAPTER 3: Installation
Speaker
HD15
Microphone
13
Advertisement
Table of Contents
