BBC Bircher ArtMotion 2 Original Instructions

ArtMotion 2
Microwave motion detector for opening automatically controlled doors
Original instructions
General
ArtMotion 2
1

Safety instructions

Observe the national and international regulations on door safety.
Only trained, qualifi ed personnel may mount and start up the detector.
The unit may only be opened and repaired by the manufacturer.
The unit may only be operated from a safety extra-low voltage (SELV) system with safe electrical separation.
Always consider the safety functions of your application as a whole, never just in relation to one individual section of the system.
The installer is responsible for carrying out a risk assessment and installing the detector and the door system correctly.
Avoid touching any electronic components.
The door drive and transom profi le must be earthed correctly.

Start-up

Recommended start-up sequence:
2

Montage

I
1. Remove cover hood

Mounting of the detector

1. Position drill template
2. Drill the holes, remove drill template
3. Lay cable and mount detector
3

Electrical connections

II
ArtMotion 2
white
Power
brown
Supply
green
Radar
yellow
output
4 Mechanical fi ne tuning
Manual settings of the
inclination
0° ... +45° in 5° steps
–
+
+
–
Radar fi eld
Radarfield
I. Mounting II. Connection
2. Lay and connect cable
Controller
white
12–36 VDC
3 m
brown
12–28 VAC
green
Cable
yellow
Radar
Wide radar fi eld
1m
2m
3m
Inclination angle: 35°
0m
1m
2m
3m
2m
4m
min. = 1.6 x 0.8 m
max. = 4.8 x 2.3 m (WxD)
3. Mount detector
turn 90°
90°
0m
1m
Hood
Light window detector indication
Cable bushing
Mounting
Microwave module
LED microwave: green
Potentiometer
Narrow radar fi eld
1m
2m
3m
Inclination angle: 35°
0m
1m
2m
3m
4m
2m
min. = 0.8 x 1.6 m
max. = 2.3 x 4.8 m (WxD)
351084B
09/19
0m
1m
1