Table of Contents
Advertisement
Quick Links
User Guide
Page:1/11
P208
CBRS Outdoor Small Cell
User Guide
Copyright © 2017 SerComm Corporation. All Rights Reserved. SerComm Corporation reserves the right
to make changes to this document without notice. SerComm Corporation makes no warranty,
representation or guarantee regarding the suitability of its products for any particular purpose.
SerComm Corporation assumes no liability arising out of the application or use of any product or circuit.
SerComm Corporation specifically disclaims any and all liability, including without limitation
consequential or incidental damages; neither does it convey any license under its patent rights, nor the
rights of others.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sercomm P208
Summary of Contents for Sercomm P208
- Page 1 SerComm Corporation assumes no liability arising out of the application or use of any product or circuit. SerComm Corporation specifically disclaims any and all liability, including without limitation consequential or incidental damages;...
-
Page 2: Replacement Parts
User Guide Page:2/11 IMPORTANT SAFETY AND INSTALLATION WARNINGS WARNING: DO NOT ATTEMPT TO SERVICE THIS PRODUCT YOURSELF AS OPENING OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS VOLTAGES OR OTHER HAZARDS. REFER ALL SERVICING TO QUALIFIED SERVICE PERSONNEL. MOUNTING: Mount this device only as described in the installation instructions, otherwise it may fall causing serious personal injury and/or damage the device. -
Page 3: Product Overview
1.1 Introduction This manual is written to help service personnel understand and install the Sercomm P208 (P208-TP or P208-OP) Citizen Broadband Radio Service (CBRS) outdoor Small Cell. This first section gives a full product description and a block diagram. The remaining sections provide component identification diagrams, installation instructions, and specifications. -
Page 4: Major Components
User Guide Page:4/11 installation for that. • A ground bolt is to connect ground with a ground cable. Ventilation valve Ground bolt RJ45 Jack 1.4 Major Components Internally, the housing bottom harbors the PCBA of the Small Cell including bluetooth. The housing top harbors the LTE omni operating CBRS antennae and network listening band 41 antenna. -
Page 5: Pre-Installation
Upon receipt of the CBRS Small Cell, inspect the carton for any external damage. If damage is present inspect the Small Cell exterior for damage. Report any apparent damage to the shipping agent and Sercomm sales office. 2.2 Power Requirements The CBRS Small Cell needs 30W power from a PoE source equipment like a DOCSIS Gateway through a Cat 5 cable. -
Page 6: Installation Diagrams
User Guide Page:6/11 2.3 Installation Diagrams Strand Mount Screw mounting kit up to the Small Cell Make strand through mounting kit clamps and then screw the bolts on the clamps to lock the strand. Finally, it will look like below: Strand Clamps Strand Hardline... - Page 7 User Guide Page:7/11 Pole Mount Loose the screws to clamp the pole by re-screwing the screws. Strand Mount with DOCSIS Gateway Strand Clamps Strand Hardline 75 ohm Coupler Coax Small Cell DOCSIS Cat 5 Gateway...
-
Page 8: Attaching The Ethernet Cable
User Guide Page:8/11 2.4 Installation Installing the device requires professional training. The device must be professionally installed by a qualified engineer familiar with system. Failure to properly install this product may result in physical injury and/or damage to property. 1. Before installing the device, please make sure the PoE source equipment (like a DOSCIS gateway that provides PoE power source) has been installed. -
Page 9: Housing Dimensions
User Guide Page:9/11 3 Small Cell Specifications 3.1 HOUSING DIMENSIONS... - Page 10 Support SSH over Public IP Address Support WINNF-TS Support SuperSON Support Support TR069 standard HeMS or HeMS Sercomm’s SuperSON Local wireless maintenance port Bluetooth Input Power Requirement From PoE Operating temperature -20oC ~ +55oC Mount Strand mount or Pole mount...
-
Page 11: Federal Communication Commission Interference Statement
User Guide Page:11/11 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the P208 and is the answer not in the manual?
Questions and answers