Table of Contents
Advertisement
Installation
Electro-static Discharge Precautions
2
Motorola strongly recommends that you use an antistatic wrist
Use ESD
strap and a conductive foam pad when installing the MPMC202.
Electronic components can be extremely sensitive to electro-static
discharge (ESD). After removing the board from the protective
wrapper, place it component side up on a grounded, static-free
surface. Do not slide the board over any surface.
Wrist Strap
Installing the MPMC202 on the Carrier Board
Follow these steps to install the MPMC202 on the carrier board:
Avoid touching areas of integrated circuitry; static
!
discharge can damage these circuits.
Caution
2-2
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
1. Place an ESD strap on your wrist and attach the grounding
line end of the ESD strap to the chassis as a ground. The ESD
strap must be secured to your wrist and to ground
throughout the procedure.
2. Remove the carrier board from the system chassis.
3. Lay the carrier board on a level surface with the PMC
connectors facing you.
4. Remove the cover from the PMC connector slot on the carrier
boardÕs front panel.
5. Remove the screws from the stand-offs on the component
side of the MPMC202.
6. Turn the MPMC202 component-side down, and position it
above the carrier board as shown in
MVME160 x carrier board is shown).
7. Insert the DB-14 external connector, J3, through the PMC
connector slot on the carrier board front panel.
Figure 2-1
(an
Advertisement
Table of Contents
