Advertisement
Universal radio-control transmitter 2
GIRA
Info
Installation Instructions
Programming of radio-control receivers
A universal radio-control transmitter channel can be
programmed into an unlimited number of radio recei-
vers. Programming information is stored only in the
radio-control receiver.
During programming of a radio-control transmitter,
the sensitivty of the receivers is reduced to approx. 5
m. The distance between the receiver and the trans-
mitter to be programmed should therefore be bet-
ween 0.5 m and 5 m.
Clearing programmed channel
Reprogramming of the transmit channel to be cleared
in the same mode of operation deletes the assign-
ment stored in the radiocontrol receiver.
Radio Transmission
Radio transmission takes place on a non-exclu-
sive path. Therefore, interference cannot be ex-
cluded. This type of radio transmission is not
suitable for safety applications such as emergen-
cy stops or emergency calls.
The range of a radio-control system depends on
transmitter power, receiver characteristics, air humi-
dity, fitting height and building conditions. The figure
illustrates the penetration of building materials by ra-
dio waves:
Dry material
Timber, gypsum, gypsum-
plasterboards
Brickwork, particle boards
Reinforced concrete
Metal, metal grating,
aluminium lamination
Rain, snow
Universal radio-control transmitter 2
Permeability
approx. 90 %
approx. 70 %
approx. 30 %
approx. 10 %
approx. 0 - 40 %
2/06
Procedure
1. Switch the radio-control receiver into the program-
ming mode (see „Radio-control receiver" operating
instructions)
2. a) Programming of operating mode A, C or D
Actuate the connected pushbutton or switch for at
least 1 s.
2. b) Programming of operating mode B
The switching telegrams of operating mode B are
not suitable for programming. Set the universal
transmitter therefore at first to operating mode A.
Press or actuate the corresponding buttons or
switches for at least 1 s. Then go back to operating
mode B.
3. Switch the radio-control receiver back into the ope-
rating mode (see „Radio-control receiver" operat-
ing instructions).
L)
Antenne
E1
E2
N
L
GY
BN
BU
BK
AC 230 V~
Page 4 of 5
Advertisement
