Configuration Steps; Additional Information - Kerio Control NG100W Quick Start Manual

Now you have two options:
• Add and manage the appliance through MyKerio (see http://kb.kerio.com/1846)
• Access the Kerio Control Administration through a browser (see below):
1. Set the networking preferences for Ethernet on the connected computer to "Automatic
DHCP configuration". (You can change it later after the configuration is complete).
2. Renew the DHCP lease on the computer and confirm it has an IP address of 10.10.10.11
3. Open a web browser and connect to the Kerio Control Administration web interface us-
ing the following URL:
https://10.10.10.1/admin
4. Ignore the SSL certificate warnings and proceed to the configuration wizard.
5. Follow the instructions provided by the wizard and configure the appliance.
See http://kb.kerio.com
Note: For troubleshooting purposes, you can use the serial port to connect the console to the
appliance. See http://kb.kerio.com/1875 for details.

5 Additional Information

For further assistance with configuration please refer to additional documentation at:
• http://kb.kerio.com/category/kerio-control/
For online and community based support resources please visit :
• http://www.kerio.com/support
© 2016 Kerio Technologies s.r.o. All rights reserved. www.kerio.com