Advertisement
Advertisement
Table of Contents
Summary of Contents for Kerio Control NG100W
- Page 1 Kerio Control NG100W, NG300W...
- Page 2 Kerio Control NG100W, NG300W 1 Purpose This document is a quick guide for safely installing and implementing Kerio Control NG100W and NG300W UTM appliances. 2 General Safety Instructions During installation follow these security instructions: • The appliance should be placed on a flat surface or securely mounted horizontally in rack enclosure. • Do not attempt to open or disassemble the appliance for any reason.
-
Page 3: Quick Installation Guide
Once a suitable place has been located for the appliance and it has been plugged into a power outlet according to the safety instructions, it is time to connect it to the network and configure settings. Figure 4 Connecting Kerio Control NG100W to the network Figure 5 Connecting Kerio Control NG300W to the network To configure the appliance: 1. Connect the antenna(s) to the hardware appliance. - Page 4 • Access the Kerio Control Administration through a browser (see below): 1. Set the networking preferences for Ethernet on the connected computer to “Automatic DHCP configuration”. (You can change it later after the configuration is complete). 2. Renew the DHCP lease on the computer and confirm it has an IP address of 10.10.10.11 3. Open a web browser and connect to the Kerio Control Administration web interface us- ing the following URL: https://10.10.10.1/admin 4. Ignore the SSL certificate warnings and proceed to the configuration wizard.
Need help?
Do you have a question about the Control NG100W and is the answer not in the manual?
Questions and answers