Alfa Romeo Giulia Owner's Handbook Manual page 64

deactivate the airbag if a rear facing
child restraint system is fitted. Always
comply with the instructions on the sun
visor (see the "Supplementary Restraint
System (SRS) - Airbag" paragraph in
"Safety" chapter).
HOMELINK
(where present)
DESCRIPTION
Homelink is a fixed system installed on
the car which allows up to three different
devices to be controlled to open garage
doors or gates, to turn lighting systems
on and off or to activate/deactivate the
home and/or office alarm system.
PROGRAMMING
WARNING Ensure that, during system
programming, any people or object are
nearby doors or gates; their movement
could cause injuries.
WARNING Put the electric parking brake
and place the ignition device to ON
without starting the engine.
Proceed as follows:
hold the outer buttons (1) and (3)
fig. 83 pressed: release both buttons
when the LED (4) starts blinking after
approximately 10 seconds;
62
83
NOTE This operation is designed to
delete the standard codes programmed
by the manufacturer. This operation
does not have to be repeated during the
subsequent button programming.
press the desired HomeLink button: (1),
(2) or (3);
when the HomeLink LED (4) begins to
flash slowly, move the portable remote
control 1 to 3 inches from the HomeLink
(keeping the button to be programmed
pressed down).
If LED (4) does not begin to flash quickly,
retry by altering the gap between the
HomeLink and the portable remote
control (move it slightly further away). If
after performing the procedure again,
the LED continues to flash slowly, repeat
the operation, altering the HomeLink -
remote control distance slightly.
The HomeLink LED (4) flashes, first
slowly and then quickly.
When the LED starts to flash quickly,
release both buttons on the remote
control.
USING THE HOMELINK SYSTEM
The HomeLink remote control activates
the operation of garage or gate door
motor, just like the portable remote
control. The vehicle should be within the
range of the motor and the key must be
inserted in the starter device.
04246S0006NA
Press the programmed button (1), (2) or
(3). While the signal is being transmitted,
LED (4) is lit and the system set (garage
door, gate, etc.) responds.
If the HomeLink system as set does
not operate, this may be due to the
fact that the original portable remote
control is equipped with an alternative
code (see paragraph "Alternative code
synchronisation").
If necessary, the original portable
remote control may always be used to
operate the system.
ALTERNATIVE CODE
SYNCHRONISATION
To check whether the garage door or
gate motor has an alternative code,
proceed as follows:
consult the garage door or gate motor
manufacturer manual;
the portable remote control seems
to have programmed the HomeLink but