Sealey BBQ04 Instructions Manual page 7

5.6 Parts list.
Item No Description
1 Barbecue body
2 Barbecue lid
3 Side shelf
4 Upper frame ("P"-"P")
5 Lower frame (feet)
6 Upper frame ("Q")
7 Lower frame (wheeled)
8 Grill
9 Flame tamer
10 Flame tamer support brkt
11 Toggle clip
12 Lid hinge
13 Barbecue hinge
14 Hub cap
15 Wheel
16 Handle
6. FITTING/REMOVAL BBQ MODULE
6.1 Fitting barbecue module to trolley frame
6.1.1. Fitting of the barbecue module to the trolley frame is best done with two people. If fitted by one person it will be necessary to chock
the wheels and frame feet to avoid accidental collapse during fitting.
6.1.2. With the trolley frame in its fullest upright position (see 610mm dimension in fig.8) and the frame suitably supported, the barbecue
module (fig.14) can be offered on to the trolley frame (fig.8).
6.1.3. Rest slightly inclined barbecue, "P" up "Q" down, on to frame item 6 in (fig.8) and pull the spring loaded catch in position "Q" (fig.14
and fig.16) through the slot and twist to register on local bracket.
6.1.4. Lower the barbecue elevated end "P" toward the frame item 4 (fig.10). Slide the operating pin of spring loaded plunger to end of slot
against the force of the spring. Locate the extended plunger into the associated barbecue hole position "P". Align frame with opposite
hole position "P" and release spring loaded plunger to self centre as in the illustration (fig.15).
WARNING! The barbecue is manufactured from light gauge mild steel, wear suitable hand protection when fitting.
r
Note! Fitting method is suggested only, the user may prefer to fit the spring loaded plunger pin first "P" and finally the catch "Q".
4
P
Slide the operating pin of spring loaded plunger to end of slot
against the force of the spring. Locate the extended plunger into the
associated barbecue hole position "P". Align frame with opposite
hole position "P" and release spring loaded plunger to self centre
© Jack Sealey Limited 2013
Qty
1
1
2
1
1
1
1
1
1
2
1
2
2
2
2
1
Fit handle (16) to lid (21) with two self tapping screws.
fig.14
P
fig.15
as in the illustration.
Original Language Version
Item No Description
17 Lid hinge pin
18 Hinge pin clip
19 M8 bolt
20 M6 X 60 round head screw
21 M6 X 12 screw
22 M5 X 10 screw
23 M3 X 10 screw
24 Washer
25 M6 Stiff nut
26 M5 Stiff nut
27 M5 nut
28 M3 nut
29 Nylon washer
30 Gas valve
31 Wheel plastic washer
32 Regulator and hose details
Venturi
Q
Q
P
Ensure the sprung loaded catch is rotated and
engaged as shown in position "Q".
Qty
2
2
2
2
2
15
2
2
2
4
11
2
2
1
2
1
fig.16
6
BBQ04 Issue: 1 - 25/02/13