Quantum LHQM Instructions

MODEL LHQM
EXIT/UNIT COMBINATION
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY
OR SIGNIFICANT PROPERTY DAMAGE – For your protection, read and follow these warnings and instructions carefully before
installing or maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations. If you do
not understand these instructions or additional information is required, contact Lithonia Lighting or your local Lithonia Lighting distributor.
WARNING:
RISK OF ELECTRIC SHOCK – NEVER CONNECT TO, DISCONNECT FROM OR SERVICE WHILE EQUIPMENT IS
ENERGIZED.
WARNING:
RISK OF FIRE – Lamps are hot. Keep combustibles material away from hot parts. Observe lamp manufacturer's
warnings, recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.
WARNING:
DO NOT USE ABRASIVE MATERIALS, OR OTHER SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE
FIXTURE, WHICH MAY RESULT IN PERSONAL INJURY.
WARNING:
RISK OF PERSONAL INJURY – This product may have sharp edges. Wear gloves to prevent cuts or abrasions when
removing from carton, handling, installing and maintaining this product. (WHERE APPLICABLE)
•
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
•
Disconnect A.C. power and unplug battery before servicing.
•
Consult your local building code for approved wiring and installation.
•
Do not use outdoors.
•
Do not let power supply cord touch hot surfaces.
•
Do not mount near gas or electric heater.
•
Do not install a damaged fixture.
•
This product must be installed in accordance with the applicable installation codes and ordinances.
•
Proper grounding is required to ensure personal safety. (WHERE APPLICABLE)
•
All service shall be performed by qualified service personnel. This product must be installed and maintained in accordance with the
applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved.
•
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
•
Halogen cycle lamps operate at high temperatures. Do not store or place flammable materials near lamp.
•
Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or eyes, flush acid with fresh
water and contact a physician immediately.
CAUTION:
Halogen cycle lamp(s) may be used in this fixture. To avoid shattering, do not operate lamp in excess of rated voltage.
Protect lamp against abrasions and scratches and against liquids when lamp is operating. Dispose of lamps with care. Halogen lamps operate
at high temperatures. Do not store or place flammable materials near lamps.
US Patent No. 5,526,251; 5,646,502; 6,142,648; D379,373; 5,611,163; D484,272; D473,672
Canadian Patent No. 80,141 & 2,180,495

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS