Installation; Apply Power To The Hub; Connect The Hub To The Lan (Local Area Network) - Ketra N4 Installation Manual

Installation

S T E P 1

Apply Power to the Hub

1. Remove a half-inch knockout from the junction box.
2. Mount the N4 to the junction box. Fit the N4's connector into the opening created in step 1. Secure
the N4 by threading the provided threaded ring onto the mount.
Notes:
Orientation: The N4's serial number (on the bottom) should face the access point. The serial
-
number may be necessary for commissioning and servicing.
Clearance: Remove nearby obstructions. This will ensure the visibility of the indicator lights as
-
well as access to all ports.
3. Splice the N4 into building power. Using the provided wire nuts, attach each lead wire to the
corresponding conductor. All connections should be made inside the junction box.
Black: Line
White: Neutral
Green: Ground
Note: Once power is connected, the N4's power indicator light will come on. It will be red while
the N4 boots up; afterward, it will turn white.
S T E P 2

Connect the Hub to the LAN (Local Area Network)

Once a connection is detected, the N4's Ethernet indicator,
D I R E C T C O N N EC T I O N TO M O D E M O R R O U T E R
continued on next page
10 | N4 INSTALLATION GUIDE
, will come on white.
© 2019 Ketra, Inc. All rights reserved
770-000027-02 r17