Page 2
Dear Customer We congratulate you on your choice of a new Haas+Sohn solid fuel stove and wish you many years of pleasure from it. You have purchased a solid fuel stove that is equipped with an innovative combustion technology and which burns the specified fuels in a very environmentally friendly and economical manner.
Page 3
------------------------------------------ The chimney -----------------------------------------...
Page 4
Faults and causes Solution 6. Exhaust gases leaking: Seek advice from a chimneysweep a) The supply pressure is too low See also 2b) b) Blockage or backward flow in the chimney c) Conditions in the building such as Close or open doors and windows windows and doors (too well) sealed.
-------------------------- General -------------------------- Dear Customer before startup, we ask you to read through these operator instructions carefully. You will then very quickly become familiar with the device’s operation. A solid fuel stove is not a toy ... The stove gets hot during operation! It is therefore essential to keep children away from it since they do not recognise the dangers that can arise in dealing with stoves.
-------------------------------------------------------------- Safety instructions -------------------------------------------------------------- The stove may only be connected by an Do not get the hotplate glowing hot and expert. The expert will find important avoid overcooking food. instructions on this subject in the Installation Doors and windows in the room where the Instructions section.
------------------------------------------------------------------------------------------------------------------- What to do in the event of problems ------------------------------------------------------------------------------------------------------------------- ------------------------------------------------------------- On startup -------------------------------------------------------------- Faults and causes Solution 1. Odours Heat the stove on low output for several hours. Then Drying out of the protective paint used operate the stove for several hours with the regulator open.
--------------------------------------------------------- Glass ceramic hob --------------------------------------------------------- Safety has priority in development and design Burnt-on sugar, The ceramic hob is very rigid mechanically and can Molten plastic should be removed immediately with a withstand minor to medium impacts without problems. glass scraper. Then clean the hob as described in If cracks or flaws appear in the hotplate as a result of Point 2.
--------------------------------------------------------------------------------------------------------------------------------------------- Dimensions and connection measurements --------------------------------------------------------------------------------------------------------------------------------------------- ------------------------------------------------ Technical data HSD 75.3 SF ------------------------------------------------ Dimensions H/W/D mm 850*/750/600 Device H/W/D mm 270/330/410 *(excl. cover hood) Oven H/W mm 180/200 Fire door opening W/D mm 214/460 Combustion area Exhaust gas connector Middle of exhaust gas connector- floor About 170 Weight...
---------------------------------------------------------------------------- Installation instructions ---------------------------------------------------------------------------- When installing stove regulations concerning building and fire safety are to be observed. If the stove is placed on a floor made of flammable materials such as wood or plastic, then the floor panel is to be attached. This panel projects beyond the stove by at least 10 cm at the sides and at least 50 cm at the front.
----------------------------------------------------------- Cleaning and care ----------------------------------------------------------- When cleaning, proceed as follows: No scouring agents or abrasive objects When dispatched the polished hotplate (optional) is should be used for regular cleaning. We recommend sealed with corrosion protection which burns without soap suds for regular care. damaging residues when first subjected to heat.
--------------------------------------------- Fruit juices dripping from baking trays may Heating with peat leave spots on the enamel that in certain --------------------------------------------- circumstances can no longer be removed. When burning peat, ensure that there is Always preheat the oven for roasting and already a lively glow since peat can only be ignited baking.
---------------------------------------------------------- Installation with flue above 1.)Remove the cover installed on the hotplate 2.) Attach exhaust gas connector from the underside and fix with screws and washers supplied. ATTENTION – The stove framework must be installed flush with the front! ---------------------------------------------------------- Connection to the chimney ---------------------------------------------------------- The chimney must be suitable for connection to the selected stove.
------------------------------------------ Control elements ------------------------------------------ On your stove you will find two operating rods on the left and right at the top of the device. Screw the control knobs supplied on to these. Shaking If you operate the knob on the combustion side of the device, you move the...
Once sufficient glow is achieved underneath, the ----------------- stove may be filled with the relevant quantity of fuel Heating for slow combustion. The air regulation appropriate ----------------- to the heating requirements of the area depends on local circumstances and therefore has to be Restricting dust emission established by experiment.
Page 16
---------------- Startup ---------------- Please perform the following steps, when you operate the stove for the first time: Remove all accessories from the ash box and oven. Rub the enamel surfaces dry. Make a small fire so that the firebricks can slowly dry out. Besides the usual new appliance smell, this may cause a small amount of smoke to be given off by the stove.
----------------------------- Air regulation ----------------------------- The speed of burning and hence the heat output of the stove depend on the volume of the combustion air flowing in under the grate. The volume of air is automatically fed in at the facing panel by means of the output regulator.
Page 18
If the distance between the side wall and the floor is too great on the side as a result of the height adjustment, this may be covered with the facing panel supplied. Simply unscrew the relevant side wall. Fix the facing panel in the desired position and refit the side wall.
----------- Oven ----------- Take all the accessories out of the oven and clean them with warm water and commercially available washing up liquid. Do not use any abrasive cleaning materials! ----------------------------------------------------- Removing the oven door ---------------------------------------------------- Open the oven door fully. Fold the safety bracket on the hinges forward (open).
Page 20
Contact us at: Telephone: +43 6769179399 (Jens Nielsen) www.j-davidssons.se info@j-davidssons.se J Davidssons Eftr. AB Phone E-mail FK-nr Swift Box 42 +46 (0)371 -200 01 Info@j-davidssons .se SE556194 -085801 NDEASESS 330 21 Reftele Homepage Bank IBAN SE 77 3000 0000 0421 Sweden +46 (0)371 -210 01 www.j-davidssons.se...
Need help?
Do you have a question about the VIKING 75 and is the answer not in the manual?
Questions and answers