Installing The Batteries In The Remote Control - Ibiza sound STANDUP308 Manual

Led illuminated active boxes with usb, sd, bluetooth, fm & remote control
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
MANUAL - STANDUP12 / 208 / 308
hout tools). Contact points can also be live. If the appliance has to be opened in order to calibrate, service,
repair or replace components or assemblies, all of its poles must be disconnected from all sources of voltage
first. If the appliance has to be kept open and under voltage during maintenance or repairs, this work may
only be carried out by a specialist who is familiar with the risks involved and the relevant regulations.
Never connect the appliance directly after transferring it from a cold to a warm room. The condensation wa-
ter that forms could destroy the appliance or result in an electric shock. Allow the device to reach room tem-
perature before connecting it. Wait until the condensation water has evaporated. This can take some hours.
Do not place any naked flames such as those of burning candles on or next to the appliance.
Do not place the appliance on soft surfaces such as carpets or beds. Do not cover the air vents of the ap-
pliance. Do not obstruct the air circulation with objects such as magazines, table cloths or curtains. This
prevents the dissipation of heat from the appliance and can result in overheating.
Only use the appliance in a moderate climate, not in tropical environments.
All persons involved in operating, installing and servicing the appliance and putting it into service must be
trained and qualified accordingly and observe these operating instructions.
Defective mains cables may only be replaced by specialists. Danger of shock hazard!
If you are not sure about the correct connection or if questions arise which are not answered by the operating
instructions, please do not hesitate to contact support or a specialist of your choice. Consult a specialist if
you are in doubt the operating principle or the safety of the product.
IMPORTANT NOTE ON LEAD-ACID BATTERIES (ONLY STANDUP12 & STANDUP208)
1. PRIOR to using the unit for the first time, please charge fully the battery without any interruption.
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely! Once the battery is fully discharged, the current drain for recharging
will be so high that it will damage the charger and/or the power supply of the unit.
4. If you don't use the unit for a longer period of time, please CHARGE THE BATTERY COMPLETELY AT 100% and check/
charge it once per month otherwise the battery will be out of use.
The life time of the battery depends on the observance of these recommendations.
We cannot be held responsible for damaged batteries further to the non-observance of these basic rules.

INSTALLING THE BATTERIES IN THE REMOTE CONTROL

Remove the battery cover from the back of the remote control as shown and insert 2x AAA size batteries ensu-
ring correct polarity
RECOMMENDATIONS FOR BATTERIES IN THE REMOTE CONTROL
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns.Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
Use of the Remote Control
Please operate the remote control within a distance of 6m and 30° between the remote and the appliance. Aim
the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Standup208Standup12

Table of Contents