Table of Contents
Advertisement
Working with LA-Stick 4x4
Mounting the spindle mechanics
13
10
12
To mount the angle mechanism on the back of the LA-Stick, the spindle (3) with locking pin holder (8) must be
released from the rotary knob (7). Hold the knob with one hand and turn the spindle out. Now you can screw
the rigid plate (2) onto the back of the LA-Stick (B) with two M6 x 30 mm screws (13). The two screws are
located on the back of the LA-Stick.
After you have mounted the rigid plate (2) on the back of the LA-Stick, screw the spindle (3) and the rotary
knob (7) together again. You can now connect the sliding plate (1) and fixed plate (2) with the locking pin (9),
the locking pin holder (8) and the ball locking pin (11). Make sure that the ball locking pin is correctly inserted
and that both locking pins are engaged.
Use the M10 clamping lever (10) to fix the sliding plate (1) to the bottom LA-Stick. To do this, remove the M10
x 25 mm hexagon socket screw on the back of the LA-Stick (A).
Separation of two LA-Stick 4x4
Loosen the M10 clamping lever (10) slightly and unlock the two locking bolts (9). Now remove the ball lock pin
(11) and pull the LA-Sticks apart. After the LA-Sticks have been disconnected, tighten the M10 clamping lever
(10) again firmly so that no whistling noises occur at the M10 thread point.
Manual LA-Stick 4x4 - 2018-07 EN
17
16
15
14
2
9
1
8
A
B
4
3
11
1.
Sliding top spindle mechanics
2.
Rigid plate spindle mechanics
3.
Spindle with M6 thread
4.
Retaining plate
5.
Ball bearing
6.
Ball bearing housing
7.
Rotary knob with M6 threaded bolt
8.
Locking pin holder with M6 internal thread
9.
Locking pin with mounting flange
10. M10 clamping lever with axial bearing
11. Ball locking pin
12. Countersunk screw M4 x 5 mm
13. Countersunk screw with hexagon socket M6 x 30 mm
14. Socket head screw M6 x 20 mm
15. 6 mm washer
16. Self-locking nut M6
17. M5 x 8 mm pan-head screw with hexagon socket
7
6
5
Page 9 of 14
Advertisement
Table of Contents
