Table of Contents
Advertisement
Working with LA-Stick 4x4
A
B
Manual LA-Stick 4x4 - 2018-07 EN
Forming a Array
When mounting several LA sticks one below the other, please note
that for optimum coupling, the front edges of the box are always
tightly joined, regardless of whether you are working with the
spindle mechanics or the tilt adapters.
B
Adjust the angle with the spindle mechanics
1.
Loosen the screw lever (A) on the bottom LA-Stick.
2.
Turn the rotary knob (B) of the spindle mechanics on the top
LA-Stick until you have set the angle.
3.
Push the LA-Sticks together at the front.
4.
Tighten the screw lever (A) again.
5.
Turn the rotary knob (B) a little bit so that some tension is
applied to the connection and nothing rattles.
Mounting the tilt adapter
There are three types with fixed angles of 0°, 4° and 8°.
A
1.
Remove the two M6 countersunk screws (B) in the top LA-Stick
and mount the tilt adapter firmly to the LA-Stick.
2.
Remove the M6 and M10 countersunk screws (A) in the lower
one and mount the tilt adapter in the two slotted holes using
two cylinder head screws with washers. Use M10 and M6 x 30 -
50 mm screws.
B
3.
Before you tighten the cylinder head screws (A), push both LA-
Sticks together so that the box edges are tightly joined at the
front for optimum coupling.
4.
Tighten the cylinder head screws (A).
Mounting the U-bracket
With the U-bracket, up to four LA-Sticks can be used one above the
other, if it is fastened accordingly.
1.
Remove the M10 and M6 countersunk screws (A) on both sides
of the LA-Stick.
2.
Use the supplied M10 and M6 knurled screws (B) including pla-
stic washers to mount the U-bracket.
3.
To protect the coatings, insert the plastic washers between the
knurled screw, U-bracket and LA-Stick.
Note: The U-bracket is only intended for vertical mounting, it is
not suitable as a ceiling bracket, as the grid is not intended for
angling in this position!
A
Page 10 of 14
Advertisement
Table of Contents
