Troubleshooting; Alarm Messages - Muller Elektronik SLURRY-Controller 3.0 Installation And Operating Instructions Manual

Troubleshooting

8

Alarm messages

8 Troubleshooting
8.1
Alarm message overview
Alarm text
Pressure is too high.
Pressure is too low.
The fill level is low.
The top link is unlocked. The speed is too
high.
In order to use this function, set the
sequence to manual.
Speed is too low.
Oil filter pressure is too high.
Maximum weight is reached. Check
whether driving on roads is allowed.
Maximum weight is reached. The front
axle has been lowered.
Target Rate is out of reach.
Application pump: Rotational speed is too
low.
Application pump: Rotational speed is too
high.
The application pump is blocked.
Overpressure in divider.
External operating device active. Before
taking over the controls, check the danger
area.
Not in transport position
54
Alarm messages
Possible cause
The pressure in the tank is too high.
The pressure in the tank is too low.
The tank is almost empty.
There is still pressure on the top link. This
can cause problems when driving on
roads.
The automatic application or filling is
activated.
A minimum speed is required for the
function you want to perform.
Overpressure in the oil filter.
The maximum weight for driving on roads
is exceeded.
The maximum weight for driving on roads
is exceeded.
The control system is not capable of
maintaining the target rate.
The rotational speed of the pump is too
low.
The rotational speed of the pump is too
high.
The pump is blocked or switched off.
The divider is clogged.
The implement is operated externally.
Moving parts are not in transport position. Put the moving parts into transport
V4.20191001
Remedial measure
Set the optimal pressure.
Set the optimal pressure.
Fill the tank.
Unlock the top link or put it in float
position.
Set the application or filling to manual.
Increase the speed.
Check the oil filter. If necessary, clean or
replace the oil filter.
Observe the permissible total weight.
Check whether the permissible total
weight can be observed with the axle
lowered.
Drive at a constant speed or control the
target rate manually.
Increase the rotational speed.
Reduce the rotational speed.
Check the pump
Remove the obstruction.
Check the danger area before operating
other functions.
position.
30322453-02-EN